Subaru Forester: To increase the speed (by accelerator pedal) - To change the cruising speed - Cruise control - Starting and operating - Subaru Forester Owner's ManualSubaru Forester: To increase the speed (by accelerator pedal)

1. Depress the accelerator pedal to accelerate the vehicle to the desired speed.

2. Push the “SET/COAST” button once.

Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal.

NOTE
If the difference between the actual vehicle speed when the button is pushed and the speed last time you set is less than 4 mph (6.8 km/h), the vehicle speed will be lowered by 1 mph (1.6 km/h). This occurs because the cruise control system unit regards this operation as that intended to decrease the vehicle speed.

    To increase the speed (by button)
    To increase the speed (by button) Push the “RES/ACC” button and hold it until the vehicle reaches the desired speed. Then, release the button. The vehicle speed at that moment will be ...

    To decrease the speed (by button)
    To decrease the speed (by button) Push the “SET/COAST” button and hold it until the vehicle reaches the desired speed. Then, release the button. The vehicle speed at that moment will be ...

    See also:

    Bluetooth® information
    Bluetooth® is the name for short-range radio frequency (RF) technology that allows electronic devices to communicate wirelessly with each other. The Land Rover Bluetooth® system supports Blu ...

    To engage the service mode
    Turn the ignition switch to the “ON” position, depress and hold the brake pedal, then press and release the “” button on the remote control transmitter three times. The system will pau ...

    Removing/installing the headlamp cover
    You must remove the headlamp cover in the engine compartment before you can replace the bulbs in the headlamp. To remove: press retaining clip 1 in the direction of the arrow. Pull cover 2 f ...