Subaru Forester: Rear window wiper blade assembly - Replacement of wiper blades - Maintenance and service - Subaru Forester Owner's ManualSubaru Forester: Rear window wiper blade assembly

1. Raise the wiper arm off the rear window.

2. Turn the wiper blade assembly counterclockwise.

2. Turn the wiper blade assembly counterclockwise.

3. Pull the wiper blade assembly toward

3. Pull the wiper blade assembly toward you to remove it from the wiper arm.

4. Install the wiper blade assembly to the wiper arm. Make sure that it locks in place.

5. Hold the wiper arm by hand and slowly lower it in position.

    Windshield wiper blade rubber
    1) Support 1. Grasp the locked end of the blade rubber assembly and pull it firmly until the stoppers on the rubber are free of the support. 1) Metal spines 2. If the new blade rubber is ...

    Rear window wiper blade rubber
    1. Pull out the end of the blade rubber assembly to unlock it from the plastic support. 2. Pull the blade rubber assembly out of the plastic support. 1) Metal spines 3. If the new blade ...

    See also:

    SRS warning lamp
    SRS functions are checked regularly when you switch on the ignition and when the engine is running. Therefore, malfunctions can be detected in good time. The SRS warning lamp in the instrument c ...

    Lap/Shoulder Belt Untwisting Procedure
    Use the following procedure to untwist a twisted lap/ shoulder belt. 1. Position the latch plate as close as possible to the anchor point. 2. At about 6 to 12 in (15 to 30 cm) above the latch pl ...

    How to Reset the Engine Oil Life System
    Reset the system whenever the engine oil is changed so that the system can calculate the next engine oil change. To reset the system: 1. Turn the ignition to ON/RUN, with the engine off. 2. Press ...