Mercedes-Benz GLK-Class: SRS warning lamp
SRS functions are checked regularly when you switch on the ignition and when the engine is running. Therefore, malfunctions can be detected in good time.
The SRS warning lamp in the instrument
cluster lights up when the ignition is switched on. It goes out no later than a
few seconds after the engine is started.
The SRS components are in operational readiness when the
SRS warning lamp is not lit while the
engine is running .
WARNING
The SRS self-check has detected a malfunction if the
SRS warning lamp:
- does not come on at all
- fails to go out approximately 4 seconds after the engine was started
- comes on after the engine was started or while driving
For your safety, Mercedes-Benz strongly recommends that you have the system checked as soon as possible at an authorized Mercedes-Benz Center. Otherwise the SRS may not be activated when it is needed in an accident, which could result in serious or fatal injury. The SRS might also deploy unexpectedly and unnecessarily which could also result in injury.
In addition, improper work on the SRS creates a risk of rendering the SRS inoperative or causing unintended air bag deployment. Work on the SRS must therefore only be performed by qualified technicians. Contact an authorized Mercedes-Benz Center.
If it is necessary to modify an air bag system to accommodate a person with disabilities, contact an authorized Mercedes-Benz Center for details. USA only: Call our Customer Assistance Center at 1-800-FOR-MERCedes (1-800-367-6372) for details.
Introduction
SRS consists of:
the SRS warning lamp
air bags
air bag control unit (with crash sensors)
Emergency Tensioning Devices
belt force limiters
SRS reduces the risk of occupants coming into ...
Safety guidelines for seat belts, Emergency Tensioning Devices (ETDs) and air
bags
WARNING
Damaged seat belts or seat belts that have been subjected to stress in
an accident must be replaced. Their anchoring points must also be checked. Only
use seat belts installed o ...
See also:
Adjusting the set speed
To change the set speed, operate the lever until the desired set
speed is obtained.
1 Increase the speed
2 Decrease the speed
Hold the lever until the desired
speed setting is obtained.
Fine a ...
Touch Screen Buttons
Touch screen buttons are on the screen and highlighted when a feature is available.
Some toggle screen buttons highlight when active and gray out when inactive. ...
Park assist
Park assist is a driving aid
only. It
remains the driver's responsibility to
drive with due care and attention
during parking manoeuvres.
Park assist may not detect moving
objects such as chil ...