Jeep Liberty: Parksense Sensors
The four ParkSense sensors, located in the rear fascia/ bumper, monitor the area behind the vehicle that is within the sensors’ field of view. The sensors can detect obstacles from approximately 12 in (30 cm) up to 79 in (200 cm) from the rear fascia/bumper in the horizontal direction, depending on the location, type and orientation of the obstacle.
Parksense Rear Park Assist — If Equipped
The ParkSense Rear Park Assist system provides visual
and audible indications of the distance between the rear
fascia and a detected obstacle when backing up, e.g.
during a parking maneuver. Refe ...
Parksense Warning Display
The ParkSense Warning screen will only be displayed if
Sound and Display is selected from the Customer- Programmable
Features section of the Electronic Vehicle
Information Center (EVIC). Refer t ...
See also:
Instrument panel light control
The brightness of the instrument panel lights can be adjusted.
1 Brighter
2 Darker
When the headlight switch is
turned on, the brightness will
be reduced slightly unless the
control dial is tu ...
Tire inflation
Check tire inflation pressure regularly.
See the tire inflation table on page 291. A tire
inflation pressure placard is also located on the
driver's side B-pillar (the structural member at
the ...
Replacing front parking lamp/turn signal bulbs
1. Make sure the headlamp control is in the off position.
2. Open the hood.
3. Reach over the front bolster.
4. Rotate the bulb socket
counterclockwise and remove from
the lamp assembly.
5. Ca ...
