Ford Escape: Replacing front parking lamp/turn signal bulbs
1. Make sure the headlamp control is in the off position.
2. Open the hood.
3. Reach over the front bolster.
4. Rotate the bulb socket
counterclockwise and remove from
the lamp assembly.
5. Carefully pull the bulb out of the
socket and push in the new bulb.
6. Install the bulb socket into the
lamp assembly and rotate clockwise.
Replacing headlamp bulbs
1. Make sure the headlamp control is in the off position. 2. Open the hood. 3. Reach over the front bolster. 4. Remove the bulb by turning it counterclockwise and then pulling it straight out. ...Replacing front sidemarker bulbs
For bulb replacement, see your authorized dealer. ...See also:
If the Engine is Flooded
If the engine is flooded with gasoline, it may be hard to start. If this happens,
press the accelerator pedal all the way to the floor and hold it there while cranking
the engine. (Do not operate ...
Detachable Anchor
The seat belt in the rear center seat
is equipped with a detachable anchor.
This allows the center seat belt to be
unlatched when the rear center seat
back is folded down or the right side
re ...
Insrtument cluster
FUEL GAUGE
The needle on the gauge indicates the approximate
fuel level in the fuel tank. The fuel capacity
is given in Section 9.
ENGINE COOLANT TEMPERATURE
GAUGE
WARNING:
Never remove ...