Subaru Forester: License plate light - Replacing bulbs - Maintenance and service - Subaru Forester Owner's ManualSubaru Forester: License plate light

1. Remove the mounting screws using a

1. Remove the mounting screws using a Phillips screwdriver.

2. Remove the cover and lens.

3. Pull the bulb out of the socket.

4. Install a new bulb.

5. Reinstall the lens and cover.

6. Tighten the mounting screws.

    Rear combination lights
    1. Using a Phillips screwdriver, remove the upper and lower screws that secure the rear combination light assembly. 2. Slide the rear combination light assembly rearward and remove it from ...

    Dome light, map light, cargo area light and door step light
    When the door is opened, the map light illuminates and becomes very hot. When replacing the map light bulb, close the door and be careful not to burn yourself. Dome light (type A) Do ...

    See also:

    Filling washer fluid
    Location of the washer fluid reservoir The windshield and headlight washers share a common reservoir. The washer fluid reservoir is located on the driver's side of the engine compartment. Duri ...

    Oil Check
    Wait a few minutes after turning the engine off before you check the oil. 1. Remove the dipstick (orange handle). 2. Wipe off the dipstick with a clean cloth or paper towel. 3. Insert the d ...

    Engine Compartment Fuse Block
    To remove the fuse block cover, squeeze the clips on the cover and lift it straight up. See Engine Compartment Overview on page 10‑6. Notice: Spilling liquid on any electrical component on ...