Subaru Forester: Rear combination lights
1. Using a Phillips screwdriver, remove the upper and lower screws that secure the rear combination light assembly.
2. Slide the rear combination light assembly rearward and remove it from the vehicle.
1) Brake/tail light
2) Rear turn signal light
3) Back-up light
3. Remove the bulb socket from the rear combination light assembly by turning it counterclockwise.
4. Pull the bulb out of the bulb socket and replace it with a new one.
5. Set the bulb socket into the rear combination light assembly and turn it clockwise until it locks.
6. Put the rear combination light assembly into place while aligning the clip with the guide on the vehicle.
7. Tighten the upper and lower screws.
Front turn signal light
It may be difficult to replace the bulbs.
Have the bulbs replaced by your SUBARU
dealer if necessary. ...
License plate light
1. Remove the mounting screws using a
Phillips screwdriver.
2. Remove the cover and lens.
3. Pull the bulb out of the socket.
4. Install a new bulb.
5. Reinstall the lens and cover.
6. Tighte ...
See also:
Audio volume and automatic volume control
The infotainment system compensates for disrupting
noises in the passenger compartment
by increasing the volume according to the
speed of the vehicle. The level of sound compensation
can be se ...
Remote starting system
This system uses the Remote
Keyless Entry
(RKE) transmitter to start the engine conveniently
from outside the vehicle while still
maintaining security. The system has a range of
approximatel ...
Monitor (if equipped)
To clean the audio/navigation monitor,
wipe it with a silicone cloth or with a soft
cloth. If the monitor is extremely dirty,
clean it with a soft cloth moistened with
neutral detergent then c ...
