Mitsubishi Outlander: Hazard warning flasher switch
Use the hazard warning flasher switch when the vehicle has to be parked on the road for any emergency. The hazard warning flashers can always be operated, regardless of the position of the ignition switch. Push the switch to turn on the hazard warning flashers, all turn signal lamps flash continuously. To turn them off, push the switch again.
Turn-signal lever
1- Turn-signals. When making a normal turn, use position (1). The lever will
return automatically when cornering is completed. 2- Lane-change signals. When moving
the lever to (2) slightly to ch ...
Fog lamp switch
Front fog lamp switch*
The front fog lamps can be operated while the headlamps and tail lamps are on.
Turn the knob in the “ON” direction to turn on the front fog lamps. An indicator
lamp i ...
See also:
Muting a Call
During a call, all sounds from inside the vehicle can be muted so that the person
on the other end of the call cannot hear them.
To mute a call, press , and then
say “Mute Call.”
To cancel m ...
Sunglasses Holder
To open the sunglasses holder, push
then release the raised detent. It will
unlatch and swing down. To close it,
push it until it latches. Make sure the
holder is closed while you are driv ...
When To Use 4WD Low Range
When off-road driving, shift to 4WD LOW for additional
traction and control on slippery or difficult terrain,
ascending or descending steep hills, and to increase
low-speed pulling power. This r ...
