Subaru Forester: Breaking-in of new brake pads and linings - Replacement of brake pad and lining - Maintenance and service - Subaru Forester Owner's ManualSubaru Forester: Breaking-in of new brake pads and linings

When replacing the brake pad or lining, use only genuine SUBARU parts. After replacement, the new parts must be broken in as follows.

Replacement of brake pad and lining
The front disc brake and the rear disc brake have audible wear indicators on the brake pads. If the brake pads wear close to their service limit, the wear indicator makes a very audible scra ...

Brake pad and lining
While maintaining a speed of 30 to 40 mph (50 to 65 km/h), step on the brake pedal lightly. Repeat this five or more times. ...

See also:

Compass (if so equipped)
When the ignition switch is turned to the ON position, the compass display B will indicate the direction of the vehicle’s heading. If the display reads “C”, calibrate the compass by d ...

SRS airbag system warning light
If the warning light exhibits any of the following conditions, there may be a malfunction in the seatbelt pretensioners and/or SRS airbag system. Immediately take your vehicle to you ...

Smart key check
If the ignition is on or the engine is running and there is no Smart Key inside the vehicle when the last door is closed, the message Smart Key Not Found Refer to Handbook will be displayed in the ...