Subaru Forester: Replacement of brake pad and lining - Maintenance and service - Subaru Forester Owner's ManualSubaru Forester: Replacement of brake pad and lining

The front disc brake and the rear disc

The front disc brake and the rear disc brake have audible wear indicators on the brake pads. If the brake pads wear close to their service limit, the wear indicator makes a very audible scraping noise when the brake pedal is applied.

If you hear this scraping noise each time you apply the brake pedal, have the brake pads serviced by your SUBARU dealer as soon as possible.

If you continue to drive despite the

If you continue to drive despite the scraping noise from the audible brake pad wear indicator, it will result in the need for costly brake rotor repair or replacement.

Hill start assist system (MT models)
Ensure that the Hill start assist system operates properly under the following circumstances: 1. Stop the vehicle on an uphill grade by depressing the brake pedal and clutch pedal, with the ...

Breaking-in of new brake pads and linings
When replacing the brake pad or lining, use only genuine SUBARU parts. After replacement, the new parts must be broken in as follows. ...

See also:

Brake booster
If the brake booster does not operate as described in the following, have it checked by your SUBARU dealer. 1. With the engine off, depress the brake pedal several times, applying the same pe ...

Tone and balance control (type A, B and C audio)
Each brief press of the “TUNE/TRACK/ CH” dial changes the control modes in the following sequence. Choose the preferred level for each mode by turning the “TUNE/TRACK/CH” dial. The ...

Fuses
Your vehicle has three types of fuses, as described below: Main Fuse – The main fuse takes current directly from the battery. Primary Fuses – These fuses are between the main fuse and individu ...