Nissan Rogue: Booster seats - Child restraints - Safety — Seats, seat belts and supplemental restraint 
system - Nissan Rogue Owner's ManualNissan Rogue: Booster seats

Precautions on booster seats

If a booster seat and seat belt are not

If a booster seat and seat belt are not used properly, the risk of a child being injured in a sudden stop or collision greatly increases:
- Make sure the shoulder portion of the belt is away from the child’s face and neck and the lap portion of the belt does not cross the stomach.

- Make sure the shoulder belt is not behind the child or under the child’s arm.

- A booster seat must only be installed in a seating position that has a lap/shoulder belt.

Booster seats of various sizes are offered by

Booster seats of various sizes are offered by several manufacturers. When selecting any booster seat, keep the following points in mind:
- Choose only a booster seat with a label certifying that it complies with Federal Motor Vehicle Safety Standard 213 or Canadian Motor Vehicle Safety Standard 213.

- Check the booster seat in your vehicle to be sure it is compatible with the vehicle’s seat and seat belt system.

- Make sure the child’s head will be properly

- Make sure the child’s head will be properly supported by the booster seat or vehicle seat. The seatback must be at or above the center of the child’s ears. For example, if a low back booster seat 1 is chosen, the vehicle seatback must be at or above the center of the child’s ears. If the seatback is lower than the center of the child’s ears, a high back booster seat 2 should be used.

- If the booster seat is compatible with your vehicle, place your child in the booster seat and check the various adjustments to be sure the booster seat is compatible with your child. Always follow all recommended procedures.

All U.S. states and Canadian provinces or

All U.S. states and Canadian provinces or territories require that infants and small children be restrained in an approved child restraint at all times while the vehicle is being operated.

The instructions in this section apply to booster seat installation in the rear seats or the front passenger seat.

    Installing top tether strap
    Installing top tether strap First secure the child restraint with the LATCH system (rear outboard seating positions only) or the seat belt as applicable. 1. Remove the anchor cover from the an ...

    Booster seat installation
    Do not use the lap/shoulder belt Automatic Locking Retractor (ALR) mode when using a booster seat with the seat belts. Refer to all Warnings and Cautions in the “Child safety”, “Chi ...

    See also:

    Refueling
    Only one person should be involved in refueling. Do not allow others to approach the area of the vehicle near the fuel filler pipe while refueling is in progress. Be sure to observe any other p ...

    System check and vehicle feature customization
    Press the SETUP button repeatedly to cycle the message center through the following features: PRESS RESET FOR ENGLISH (if in another language) When entering the setup menu and a non-English lang ...

    Electrical power outlet
    Your vehicle is equipped with a fused 12 Volt (13 Amp) power outlet. This power outlet is located on the instrument panel, below the climate controls. It has power available when the ignition sw ...