Nissan Rogue: Installing top tether strap
Installing top tether strap
First secure the child restraint with the LATCH system (rear outboard seating positions only) or the seat belt as applicable.
1. Remove the anchor cover from the anchor point which is located directly behind the child seat.
2. Position the top tether strap over the top of the seatback.
3. Secure the tether strap to the tether anchor bracket that provides the straightest installation.
4. Tighten the tether strap according to the manufacturer’s instructions to remove any slack.
If you have any questions when installing a top tether strap, consult your NISSAN dealer for details.
Forward-facing child restraint installation using the
seat belts
- The three-point seat belt with Automatic
Locking Retractor (ALR) must
be used when installing a child
restraint. Failure to use the ALR
mode will result in the child restraint
not bein ...
Booster seats
Precautions on booster seats
If a booster seat and seat belt are not
used properly, the risk of a child being
injured in a sudden stop or collision
greatly increases:
- Make sure the shou ...
See also:
Check Fuel Cap Message
If your fuel fill cap is loose or
missing, a ‘‘CHECK FUEL CAP’’
message appears on the information
display after you start the engine. ...
Multi-Band Antenna
The multi-band antenna is on the roof of the vehicle. The antenna is used for
the AM&-FM radio, OnStar, the XM Satellite Radio Service System, and GPS (Global
Positioning System), if the vehic ...
Customer Key Programming
If you have two valid Sentry Keys , you can program
new Sentry Keys to the system by performing the
following procedure:
1. Cut the additional Sentry Key Transponder blank(s)
to match the ignit ...
