Nissan Rogue: Booster seat installation - Child restraints - Safety — Seats, seat belts and supplemental restraint 
system - Nissan Rogue Owner's ManualNissan Rogue: Booster seat installation

Do not use the lap/shoulder belt Automatic

Do not use the lap/shoulder belt Automatic Locking Retractor (ALR) mode when using a booster seat with the seat belts.

Refer to all Warnings and Cautions in the “Child safety”, “Child restraints” and “Booster seats” sections earlier in this section before installing a child restraint.

Follow these steps to install a booster seat in the

Follow these steps to install a booster seat in the rear seat or in the front passenger seat:

1. If you must install a booster seat in the front seat, move the seat to the rearmost position.

2. Position the booster seat on the seat. Only place it in a forward-facing direction. Always follow the booster seat manufacturer’s instructions.

Front passenger position
Front passenger position

3. The booster seat should be positioned on the vehicle seat so that it is stable.

If necessary, adjust or remove the head restraint to obtain the correct booster seat fit. If the head restraint is removed, store it in a secure place. Be sure to reinstall the head restraint when the booster seat is removed. See “Head restraints” earlier in this section for head restraint adjustment, removal and installation information.

If the seating position does not have an adjustable head restraint or headrest and it is interfering with the proper booster seat fit, try another seating position or a different booster seat.

4. Position the lap portion of the seat belt low and snug on the child’s hips. Be sure to follow the booster seat manufacturer’s instructions for adjusting the seat belt routing.

5. Pull the shoulder belt portion of the seat belt toward the retractor to take up extra slack.

Be sure the shoulder belt is positioned across the top, middle portion of the child’s shoulder. Be sure to follow the booster seat manufacturer’s instructions for adjusting the seat belt routing.

6. Follow the warnings, cautions and instructions for properly fastening a seat belt shown in “Seat belts” earlier in this section.

7. If the booster seat is installed in the front

7. If the booster seat is installed in the front passenger seat, turn the ignition switch to the ON position. The front passenger air bag status light illuminate may or may not illuminate depending on the size of the child and the type of booster seat used. See “Front passenger air bag and status light” later in this section.

    Booster seats
    Precautions on booster seats If a booster seat and seat belt are not used properly, the risk of a child being injured in a sudden stop or collision greatly increases: - Make sure the shou ...

    See also:

    Setting the airflow
    Turn the SmartKey to position 2 in the ignition lock. To increase/reduce: press the or button. ...

    Lighting panel
    Overview, light switches 1 Thumb wheel for adjusting display and instrument lighting 2 Rear fog light 3 Headlights/parking lights Instrument lighting Illumination of the display and instrumen ...

    System fault
    If a fault is detected in the HDC system, an HDC warning will be displayed in the message centre. If the fault is detected while the system is operating, HDC will then fade out. If a fault is det ...