Toyota RAV4: When the power window does not close normally
If the jam protection function is operating abnormally and a window cannot be closed, perform the following operations using the power window switch on the driver's door.
●Vehicles without smart key system: After stopping the vehicle, the window
can be closed by holding the power window switch in the one-touch
closing position while the engine switch is turned to the “ON” position.
●Vehicles with smart key system: After stopping the vehicle, the window
can be closed by holding the power window switch in the one-touch closing
position while the “ENGINE START STOP” switch is turned to IGNITION
ON mode.
●If the window still cannot be closed even by carrying out the operation
explained above, initialize the function by performing the following procedure.
1 Hold the power window switch in the one-touch closing position. Continue holding the switch for a further 6 seconds after the window has closed. 2 Hold the power window switch in the one-touch opening position. Continue holding the switch for a further 2 seconds after the window has opened completely. 3 Hold the power window switch in the one-touch closing position once again. Continue holding the switch for a further 2 seconds after the window has closed.
If you release the switch while the window is moving, start again from the beginning. If the window continues to close but then re-open slightly even after performing the above procedure correctly, have the vehicle inspected by your Toyota dealer.
CAUTION
■Closing the windows
Observe the following precautions.
Failing to do so may result in death or serious injury.
●Check to make sure that all passengers do not have any part of their body
in a position where it could be caught when a window is being operated.
●Do not allow children to operate the power windows.
Closing a power window on someone can cause serious injury, and in
some instances, even death.
■Jam protection function (driver’s window only)
●Never try jamming any part of your body to activate the jam protection
function intentionally.
●The jam protection function may not work if something gets caught just
before the window fully closes.
Lock switch
Press the switch down to lock the passenger window switches. Use this switch to prevent children from accidentally opening or closing a passenger window. ■The power windows can be operate ...Moon roof
Use the overhead switches to open, close, and tilt the moon roof up and down. ■ Opening and closing 1 Open The moon roof stops slightly before the fully open position to reduce wind nois ...See also:
Headlamp control
Rotate the headlamp control to the
first position to turn on the
parking lamps.
Rotate to the second position
to
turn on the headlamps.
Rotate back to to turn the
headlamps off.
...
System self-test
After you have switched on the ignition, the system carries out a self-diagnosis.
WARNING
A malfunction in the system has been detected if one of the following conditions
occurs:
the indi ...
Brake/Clutch fluid
Brake and clutch (if equipped) systems are supplied from the same
reservoir.
The fluid level will drop slowly as the
brakes wear, and will rise when the
brake components are replaced. Fluid
lev ...