Nissan Rogue: Trailer lights
When splicing into the vehicle electrical system, a commercially available power-type module/converter must be used to provide power for all trailer lighting. This unit uses the vehicle battery as a direct power source for all trailer lights while using the vehicle tail light, stoplight and turn signal circuits as a signal source. The module/converter must draw no more than 15 milliamps from the stop and tail lamp circuits. Using a module/converter that exceeds these power requirements may damage the vehicle’s electrical system.
See a reputable trailer dealer to obtain the proper equipment and to have it installed.
Trailer lights should comply with federal and/or local regulations. For assistance in hooking up trailer lights, contact a NISSAN dealer or reputable trailer dealer.
Safety chains
Always use a suitable chain between your
vehicle and the trailer. The safety chains should
be crossed and should be attached to the hitch,
not to the vehicle bumper or axle. The safety
chains ...
Trailer brakes
If your trailer is equipped with a braking system,
make sure it conforms to federal and/or local
regulations and that it is properly installed.
Never connect a trailer brake system
directly ...
See also:
Additional Cleaning Procedure
For additional cleaning assistance in removing stubborn
stains, apply MOPAR Convertible Cloth Top Cleaner or
equivalent to the complete stain, extending 2 in (50 mm)
beyond the stain. With a sof ...
Cold weather precautions
If you wish to check your vehicle before the
approach of cold weather, the following advice
is worth noting:
• Make sure that the engine coolant contains
50 percent antifreeze. Any other mixt ...
Instrument Panel
A. Air Vents on page 8‑5.
B. Turn and Lane&-Change Lever. See Turn and Lane-Change Signals on page 6‑3. Exterior
Lamp Controls on page 6‑1. Fog Lamps on page 6‑4.
C ...
