Subaru Forester: Tire care – maintenance and safety practices
- Check on a daily basis that the tires are free from serious damage, nails, and stones. At the same time, check the tires for abnormal wear.
- Inspect the tire tread regularly and replace the tires before their tread wear indicators become visible.
When a tire’s tread wear indicator becomes visible, the tire is worn beyond the acceptable limit and must be replaced immediately.
With a tire in this condition, driving at even low speeds in wet weather can cause the vehicle to hydroplane.
Possible resulting loss of vehicle control can lead to an accident.
- To maximize the life of each tire and ensure that the tires wear uniformly, it is best to rotate the tires every 7,500 miles (12,000 km).
For information about the tire rotation order, refer to “Tire rotation”.
Replace any damaged or unevenly worn tires at the time of rotation. After tire rotation, adjust the tire pressures and make sure the wheel nuts are correctly tightened.
For information about the tightening torque and tightening sequence for the wheel nuts, refer to “Flat tires”.
Glossary of tire terminology
- Accessory weight The combined weight (in excess of those standard items which may be replaced) of automatic transmission, power steering, power brakes, power windows, power seats, radio, ...Vehicle load limit – how to determine
The load capacity of your vehicle is determined by weight, not by available cargo space. The load limit of your vehicle is shown on the vehicle placard attached to the driver’s side B-pill ...See also:
Seat belt pretensioners (front seats)
The pretensioner helps the seat
belt to quickly restrain the occupant
by retracting the seat belt
when the vehicle is subjected to
certain types of severe frontal
collision or a vehicle rollove ...
Fuse box in the engine compartment
Make sure that the windshield wipers are turned off.
WARNING
Make sure that the windshield wipers are switched off and that
the SmartKey is removed from the ignition lock before you open ...
Compass Calibration
If you see ‘‘- -’’ in the direction
display when you turn the ignition
switch to the ON (II) position, the
compass is self-calibrating.
The compass may need to be
manually calibrate ...