Mercedes-Benz GLK-Class: Resetting to factory settings - Settings menu - Menus and submenus - On-board computer and displays - Mercedes-Benz GLK-Class Owner's ManualMercedes-Benz GLK-Class: Resetting to factory settings

For safety reasons, the Daytime Running Lights: function in the Lights submenu is only reset when the vehicle is stationary.

  • Press the button on the steering wheel to or select the Settings menu. button on the steering wheel to select the Settings menu.
  • Press the button to select the Factory Setting or submenu. button to select the Factory Setting submenu.
  • Press the The Reset All Settings? message appears. button to confirm. The Reset All Settings? message appears.
  • Press the button to select No or Yes. or Press the  button to confirm button to select No or Yes.
  • Press the the selection. button to confirm the selection.

If you select Yes, the multifunction display shows a confirmation message.

    Convenience
    Activating/deactivating the EASYENTRY/ EXIT feature You can use the Easy Entry/Exit: function to activate or deactivate the EASY ENTRY/ EXIT feature (). WARNING You must make sure no one can ...

    See also:

    Compass Messages
    CAL This message is displayed when the compass needs to be calibrated. See Compass on page 5‑5. – – – Three dashes will be displayed if the compass needs service. See your dealer fo ...

    Ignition mode I
    NOTE To access ignition modes I or II without starting the engine, the brake pedal must not be depressed. - With the remote key fully pressed into the ignition slot, press START/STOP ENGINE ...

    Replacing a Front Turn Signal Light Bulb
    1. Open the hood. To change the turn signal bulb on the driver’s side, remove the engine coolant reserve tank by pulling it out of its holder. 2. Remove the socket from the headlight a ...