GMC Terrain: Replacing Safety Belt System Parts after a Crash - Safety Belts - Seats and Restraints - GMC Terrain Owner's ManualGMC Terrain: Replacing Safety Belt System Parts after a Crash

GMC Terrain / GMC Terrain Owner's Manual / Seats and Restraints / Safety Belts / Replacing Safety Belt System Parts after a Crash

WARNING

A crash can damage the safety belt system in the vehicle. A damaged safety belt system may not properly protect the person using it, resulting in serious injury or even death in a crash. To help make sure the safety belt systems are working properly after a crash, have them inspected and any necessary replacements made as soon as possible.

After a minor crash, replacement of safety belts may not be necessary. But the safety belt assemblies that were used during any crash may have been stressed or damaged. See your dealer to have the safety belt assemblies inspected or replaced.

New parts and repairs may be necessary even if the safety belt system was not being used at the time of the crash.

Have the safety belt pretensioners checked if the vehicle has been in a crash, or if the airbag readiness light stays on after you start the vehicle or while you are driving. See Airbag Readiness Light on page 5‑11.

    Safety Belt Care
    Keep belts clean and dry. WARNING Do not bleach or dye safety belts. It may severely weaken them. In a crash, they might not be able to provide adequate protection. Clean safety belts only with mi ...

    See also:

    Automatic Transmission
    The “DRIVE” range can be selected when towing. However, if frequent shifting occurs while in this range, activate the TOW/HAUL feature. Refer to “Automatic Transmission” in “Starting a ...

    Tire Inspection
    Every time you check inflation, you should also examine the tires for damage, foreign objects, and wear. You should look for: Bumps or bulges in the tread or side of the tire. Replace the tire ...

    Compliance
    FCC/IC common sentence This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, ...