Toyota RAV4: Replacing a flat tire
Chock the tires.
2 Remove the wheel ornament using the wheel nut wrench as shown below.
16-inch wheel
To protect the wheel ornament, place a rag between the wrench and the wheel ornament, as shown in the illustration.
17-inch and 18-inch wheels
Slightly loosen the wheel nuts (one turn).
Turn the tire jack portion “A” by hand until the notch of the jack is in contact with the jack point.
Type A: Assemble the jack handle extension.
Type B: Assemble the jack handle extension.
6 Raise the vehicle until the tire is slightly raised off the ground.
Type A
Type B
Type C
Remove all the wheel nuts and the tire. When resting the tire on the ground, place the tire so that the wheel design faces up to avoid scratching the wheel surface.
Taking out the spare tire (vehicles without the spare tire cover)
Using the wheel nut wrench,
loosen the hold-down nuts by
turning them counterclockwise
until they can be loosened by
hand. Follow the order shown in
the illustration.
2 Remove all the wheel nu ...
Installing the tire
Remove any dirt or foreign matter
from the wheel contact surface.
If foreign matter is on the wheel
contact surface, the wheel nuts
may loosen while the vehicle is
in motion, and the tire may
...
See also:
What is an Onboard Diagnostic System (OBD II)?
OBD II is part of your vehicle's computerized
engine management system. It stores diagnostic
information about your vehicle's emission
controls. It can light the Check Engine light
(MIL) if it ...
Combining safety belt and LATCH lower anchors for attachingchild safety seats
When used in combination, either the safety belt or the LATCH lower
anchors may be attached first, provided a proper installation is achieved.
Attach the tether strap afterward, if included with t ...
Parking brake
To park the vehicle, first bring in to a complete stop, fully engage the parking
brake.
To apply
1- Pull the lever up without pushing the button at the end of hand grip.
To release
1- Pull t ...
