Volvo XC60: Re-installing the wheel
1. Clean the contact surfaces on the wheel and hub.
2. Lift the wheel and place it on the hub.
Tighten the lug nuts
3. Install the wheel nuts and tighten handtight.
Using the lug wrench, tighten crosswise until all nuts are snug.
4. Lower the vehicle to the ground and alternately tighten the bolts crosswise to 103 ft. lbs. (140 Nm).
5. Install the wheel cover (where applicable).
The opening in the wheel cover for the tire's inflation valve must be positioned over the valve.
Changing a wheel
1. Apply the parking brake and put the gear selector in P. 2. Take out the jack*, lug wrench*, the towing eyelet and the wheel cover removal tool* stowed under the floor of the trunk. 3. Remov ...Tire Pressure Monitoring System (TPMS)
Introduction NOTE USA – FCC ID: KR5S122780002 This device complies with part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful int ...See also:
Capacities
...
Important safety notes
WARNING
The PARKTRONIC is a supplemental system. It is not intended to, nor does it replace,
the need for extreme care. The responsibility during parking and other critical
maneuvers always ...
Removing the Flat Tire and Installing the Spare Tire
1. Do a safety check before proceeding. See If a Tire Goes Flat on page 10‑65
for more information.
2. For vehicles with a wheel cover or center cap, pull the cover or center cap
away from ...