Subaru Forester: Position light - Replacing bulbs - Maintenance and service - Subaru Forester Owner's ManualSubaru Forester: Position light

1. Turn the bulb socket counterclockwise

1. Turn the bulb socket counterclockwise and pull out the socket.

2. Pull the bulb out of the socket.

3. Install a new bulb.

4. Install the bulb socket by turning it clockwise.

    High beam light bulbs
    Right-hand side 1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct (right-hand side). 2. Disconnect the electrical connector from the bulb. 3 ...

    Front turn signal light
    It may be difficult to replace the bulbs. Have the bulbs replaced by your SUBARU dealer if necessary. ...

    See also:

    Reprogramming a Single HomeLink Button
    To program a device to HomeLink using a HomeLink button previously trained, follow these steps: 1. Press and hold the desired HomeLink button. DO NOT release the button. 2. The indicator light ...

    Precautions when the vehicle is being towed
    • Attach jumper cables (see page 114) to provide current for releasing the electric parking brake and to move the gear selector from the P position to N. • Be sure that the steering wheel l ...

    Engine block heater (if so equipped)
    Engine block heaters are used to assist in cold temperature starting. The engine block heater should be used when the outside temperature is 208F (−78C) or lower. To use the engine block h ...