Mitsubishi Outlander: Interior lamps
1- Luggage room lamp 2- Room lamp (rear). 3- Map & room lamps (front). 4- Foot lamps* P. 8-58.
NOTE:
● If you leave the lamps on without running the engine, you will run down the battery.
Before you leave the vehicle, make sure the lamps are turned off.
Room lamps
1- (DOOR). The lamp illuminates when a door or the tailgate is opened, and when the door or tailgate is closed the lamp dims for about 15 seconds before going out. However, the lamp immediately goes out in the following cases. • When the doors and the tailgate are closed and the ignition switch is turned to the “ON” position. • When the doors and the tailgate are closed and the central door lock function is used to lock the vehicle.
• If the vehicle is equipped with the keyless entry system, when the keyless entry system remote control switch is used to lock the vehicle. • If the vehicle is equipped with the keyless operation system, when the keyless operation function is used to lock the vehicle.
NOTE:
● For vehicles equipped with keyless entry system, if the key was used to start
the engine, when the doors and tailgate are closed the lamp illuminates when the
key is removed, and after about 15 seconds it goes out.
● If the keyless operation function was used to start the engine, when the doors
and tailgate are closed the lamp illuminates when the ignition switch is turned
to the “LOCK” position, and after about 15 seconds it goes out.
● The time until the lamp goes out can be adjusted. For details, please consult
a MITSUBISHI MOTORS Authorised Service Point. For vehicles equipped with the HDD
navigation Mitsubishi Multi-Communication System (MMCS), adjustments can be made
using screen operations. For details, refer to the separate owner’s manual. 2- (OFF).
The lamp stays off regardless of whether the doors and tailgate are open or closed.
1- (ON). The lamp illuminates regardless of whether the doors and tailgate are open or closed. 2-. The lamp illuminates when a door or the tailgate is opened, and when the door or tailgate is closed the lamp dims for about 15 seconds before going out. However, the lamp immediately goes out in the following cases. • When the doors and the tailgate are closed and the ignition switch is turned to the “ON” position. • When the doors and the tailgate are closed and the central door lock function is used to lock the vehicle. • If the vehicle is equipped with the keyless entry system, when the keyless entry system remote control switch is used to lock the vehicle. • If the vehicle is equipped with the keyless operation system, when the keyless operation function is used to lock the vehicle.
NOTE:
● For vehicles equipped with keyless entry system, if the key was used to start
the engine, when the doors and tailgate are closed the lamp illuminates when the
key is removed, and after about 15 seconds it goes out.
● If the keyless operation function was used to start the engine, when the doors
and tailgate are closed the lamp illuminates when the ignition switch is turned
to the “LOCK” position, and after about 15 seconds it goes out.
● When the room lamp switch is in the “ON” position, the lamp does not go out, even
if the doors and tailgate are closed.
● The time until the lamp goes out can be adjusted. For details, please consult
a MITSUBISHI MOTORS Authorised Service Point. For vehicles equipped with the HDD
navigation Mitsubishi Multi-Communication System (MMCS), adjustments can be made
using screen operations. For details, refer to the separate owner’s manual. 3- (OFF).
The lamp stays off regardless of whether the doors and tailgate are open or closed.
1- (ON). The lamp illuminates regardless of whether the tailgate is open or closed. 2-. The lamp illuminates when the tailgate is opened, and goes out when the tailgate is closed. 3- (OFF). The lamp goes out regardless of whether the tailgate is open or closed.
Map lamps
Push the lens (A) to turn on the lamp. Push it again to turn it off.
Lamps (room lamps, etc.) auto-cutout function
If any of the interior lamps are left switched on with the ignition switch in any position other than “ON” or “ACC”, it goes off automatically after approximately 30 minutes to prevent complete discharge of the battery. The interior lamps will illuminate again if the ignition switch is set to the “ON” or “ACC” position, if one of the doors or the tailgate is opened and closed, or if the keyless entry system or keyless operation system is operated.
NOTE:
● The interior lamp auto-cut function can be deactivated. For details and support,
consult your nearest MITSUBISHI MOTORS Authorised Service Point. For vehicles equipped
with the HDD navigation Mitsubishi Multi-Communication System (MMCS), adjustments
can be made using screen operations. For details, refer to the separate owner’s
manual.
Accessory socket
CAUTION: ● Be sure to use a “plug-in” type accessory operating at 12 V and at 120 W or less. When using more than one socket at the same time, make sure that the electrical accessories ...Storage spaces
CAUTION: ● Never leave lighters, canned carbonated beverage, and spectacles in the cabin when parking the vehicle in hot sunshine. The cabin will become extremely hot, so lighters and othe ...See also:
Engine oil
For the checking, adding and replacing procedure or other details, refer to
“Engine oil”.
NOTE
The procedure for changing the engine oil and oil filter should be performed by
a properly-tra ...
Wireless remote control
The wireless remote control can be used to lock and unlock the vehicle
from outside the vehicle.
Vehicles without smart key system
1 Locks all doors
2 Pushing and holding: Sounds alarm
3 Unlock ...
Ignition Positions
The ignition switch has four different positions.
Notice: Using a tool to force the key to turn in the ignition could cause damage
to the switch or break the key. Use the correct key, make sure i ...