Mitsubishi Outlander: Accessory socket - For pleasant driving - Mitsubishi Outlander Owner's ManualMitsubishi Outlander: Accessory socket

CAUTION:
● Be sure to use a “plug-in” type accessory operating at 12 V and at 120 W or less. When using more than one socket at the same time, make sure that the electrical accessories are 12 V accessories and that the total power consumption does not exceed 120 W.
● Long use of the electric appliance without running the engine may run down the battery.
● When the accessory socket is not in use, be sure to close the lid or install the cap, because the socket might become clogged by foreign material and be short-circuited.

To use a plug-in type accessory, open the lid or remove the cap, and insert the plug in the accessory socket.

NOTE:
● Accessory sockets in 3 locations can be used at the same time. However, make sure that the total power consumption does not exceed 120 W.

The accessory socket can be used while the ignition switch is in either the “ON”

The accessory socket can be used while the ignition switch is in either the “ON” or “ACC” position.

Interior lamps

    Vanity mirror
    The vanity mirrors are located on the back of the sun visor. ...

    Interior lamps
    1- Luggage room lamp 2- Room lamp (rear). 3- Map & room lamps (front). 4- Foot lamps* P. 8-58. NOTE: ● If you leave the lamps on without running the engine, you will run down the batt ...

    See also:

    Removing the wheel cover
    Removing the wheel cover 1) Notch 2) Valve hole Insert a wheel cover remover into the notch part on the opposite side of the valve hole and pry the wheel cover to remove it. ...

    Stowing third seats (vehicles with third seats)
    ■ Before stowing the third seats Stow the third seat belt buckles. Pass the seat belts through the seat belt hangers. This prevents the shoulder belt from being damaged. 3 Lower the he ...

    Changing voice tag
    1. Select the “CHANGE NAME” menu. 2. Select the phone number by operating the “TUNE/TRACK/CH” dial/by pressing the talk switch and saying the voice tag. 3. Select the “CONFIRM” me ...