Volvo XC60: Installing the cover - Cargo area cover - Cargo area - During your trip - Volvo XC60 Owner's ManualVolvo XC60: Installing the cover

1. Press the end piece on one side of the cargo area cover into the retaining bracket in the side panel of the cargo area 1.

2. Do the same on the opposite side 2.

3. Press both sides of the cover until they click into place 3. The red mark will no longer be visible.

4. Check that both ends of the cover are securely locked in place.

    Use
    • Pull the cover over the cargo and hook it into the holes in the rear cargo area pillars. • To retract (roll up) the cover, release it from the holes and guide it toward the rear seat back ...

    Removing the cover
    1. Press one of the end pieces of the cover inward. 2. Pull the cover carefully upward and outward. The other end will release automatically from its retaining bracket. ...

    See also:

    Rear Tail/Stop, Turn Signal, And Back-Up Lamp
    1. Open the liftgate. 2. Remove the screws that fasten the taillamp housing to the vehicle. 3. Pull the taillamp housing straight back to separate it from the vehicle. 4. Disconnect the elect ...

    Programming A Rolling Code
    For programming garage door openers that were manufactured after 1995. These garage door openers can be identified by the “LEARN” or “TRAIN” button located where the hanging antenna is a ...

    Tail lamp
    Switch off the lights. Open the cargo compartment. Open the side trim panel (). Pull out connector 2. Press retaining lugs 1 simultaneously in the direction of the arrow and pull t ...