Volvo XC60: Immobilizer (start inhibitor) - Introduction - Remote key and key blade - Locks and alarm - Volvo XC60 Owner's ManualVolvo XC60: Immobilizer (start inhibitor)

Each of the keys supplied with your vehicle contains a coded transponder. The code in the key is transmitted to an antenna in the ignition slot where it is compared to the code stored in the start inhibitor module. The vehicle will start only with a properly coded key. If you misplace a key, take the other keys to a trained and qualified Volvo service technician for reprogramming as an anti-theft measure. The following messages (which may appear in the instrument panel display) are related to the immobilizer:

CAUTION

CAUTION Never use force when inserting the remote key in the ignition slot. The vehicle cannot be started if the transponder is damaged.

USA–FCC ID: LTQWFS 125VO

This device complies with part 15 of the FCC rules. Operation is subject to the following condition:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Canada–IC: 3659A-WFS125VO

Operation is subject to the following conditions:

(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

See page 112 for information on starting the vehicle.

    Confirmation when locking/unlocking the vehicle
    Settings can be made in the menu system for audible and visual confirmation when the vehicle has been locked or unlocked. With these functions activated, the following will occur when the vehi ...

    Replacing the battery in the remote key
    The batteries should be replaced if: • The information symbol illuminates and Low battery in remote control. Please change batteries. is shown in the display and/or • if the locks do not r ...

    See also:

    Conference Call
    When two calls are in progress (one active and one on hold), press and hold the button until you hear a double beep indicating that the two calls have been joined into one conference call. ...

    Replacing an air filter
    1. Remove the glove box. (1) Open the glove box. (2) Remove the damper shaft from the glove box. (3) Pull out the glove box. 2. Remove the air filter. 3. Replace the air filter element ...

    Operating tips
    To get the best performance out of the NISSAN Voice Recognition system, observe the following: - Keep the interior of the vehicle as quiet as possible. Close the windows to eliminate surroundi ...