Subaru Forester: Headlight flasher
Headlight flasher
To flash the headlights, pull the lever toward you and then release it. The high beam will remain on for as long as you hold the lever. The headlight flasher works even though the light switch is in the “OFF” position.
When the headlights are on high beam,
the high beam indicator light “
” on
the
combination meter also illuminates.
Do not hold the lever in the flashing position for more than just a few seconds.
High/low beam change (dimmer)
High/low beam change (dimmer)
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light “” on the
c ...
Daytime running light system (if equipped)
The brightness of the illumination of
the high beam headlights is reduced
by the daytime running light system.
The light switch must always be
turned to the “” position
when it
is ...
See also:
Compact Spare Tire
Use the compact spare tire as a
temporary replacement only. Get
your regular tire repaired or replaced,
and put it back on your vehicle as
soon as you can.
Check the air pressure of the
com ...
Disabling And Enabling HSA
This feature can be turned on or turned off. To change the
current setting, proceed as follows:
For vehicles equipped with the Electronic Vehicle Information
Center (EVIC), refer to “Hill Start ...
RSE menus
IntroductionSettings in the RSE menus can be made
from
the front center console control panel or by
using the remote control in the rear seat. A
source for one of the rear screens can be activ ...
