Volvo XC60: Hazard warning flashers
Location of the hazard warning flasher button
The hazard warning flasher should be used to indicate that the vehicle has become a traffic hazard.
To activate the flashers, press the button in the center dash. Press the button again to turn off the flashers.
NOTE
• Regulations regarding the use of the
hazard warning flasher may vary,
depending on where you live.
• The hazard warning flashers will be activated
automatically if an airbag
deploys.
Rear fog light
Rear fog light
The single rear fog light is located in the driver's
side taillight cluster. The rear fog light will only
function in combination with the high/low
beam headlights.
Press the ...
Turn signals
Turn signals
When changing lanes
1 The driver can automatically flash the turn
signals 3 times by moving the turn signal lever
up or down to the first position and releasing it.
When turning
...
See also:
Towing
The rear sensors are automatically disabled
when a trailer with an approved electrical
connector is connected.
Note: Trailers fitted with LED lights will not
disable the rear parking aids sensors. ...
Compass zone adjustment
Compass calibration zones
1. The zone setting is factory preset to
Zone 8. Refer to the “Compass calibration
zones” map shown above to verify that the
compass zone setting is correct fo ...
Antenna location and effective range
■ Antenna location
1 Antennas outside the cabin
2 Antennas inside the cabin
3 Antenna outside the luggage
compartment ...
