Volvo XC60: Function check - Indicator, information, and warning symbols - Instruments and controls - Your driving environment - Volvo XC60 Owner's ManualVolvo XC60: Function check

All indicator and warning symbols light up in ignition mode II or when the engine is started.

When the engine has started, all the symbols should go out except the parking brake symbol, which only goes out when the brake is disengaged.

If the engine does not start or if the function check is carried out in ignition mode II, all symbols go out after 5 seconds except the symbol for faults in the vehicle's emissions system and the symbol for low oil pressure.

Certain symbols may not have their functions illustrated, depending on the vehicle's equipment.

    Indicator, information, and warning symbols
    Indicator and warning symbols 1 High beam and turn signal indicators 2 Indicator and warning symbols 3 Information symbols 4 Indicator and warning symbols ...

    Indicator and information symbols
    Fault in the Active Bending Light (ABL) system This symbol will illuminate if the there is a fault in the ABL system. See page 93 for more information about this system. Malfunction ...

    See also:

    How do states use OBD II for emission inspections?
    Many states connect a computer directly to a vehicle's OBD II system. The inspector can then read "faults." In some states, this type of inspection has replaced the tailpipe emission ...

    Connecting a trailer
    1. Remove the receiver cover from the hitch receiver tube. Then insert the ball mount into the hitch receiver tube. 2. Insert the hitch pin into the hole on the hitch receiver tube so that ...

    ESN/SID Access
    With the ignition switch in the ON/RUN or ACC position and the radio on, press the SETUP button and scroll using the TUNE/SCROLL control knob until Sirius ID is selected. Press the TUNE/SCROLL c ...