Jeep Liberty: Driver Memory Seat — If Equipped
This feature allows the driver to store up to two different memory profiles, for easy recall through a memory switch. Each memory profile contains desired position settings for the driver seat and side mirrors and a set of desired radio station presets.
The memory switch is located on the instrument panel to the left of the steering column. The switch contains a S (SET) button to activate the memory save function. It also contains a rocker switch labeled with the number (1) and the number (2). The rocker switch allows the driver to recall either of the two pre-programmed memory profiles by pressing the appropriate side of the switch.
Driver Memory Switch
- Programming The Memory Feature
- Linking And Unlinking The Remote Keyless Entry Transmitter To Memory
- Memory Position Recall
- Easy Entry/Exit Seat (Available With Memory Seat Only)
Recliner Adjustment
The rear seatback also reclines for additional passenger
comfort. Pull the release strap while sitting in the rear
seat to recline the seatback.
Rear Seatback Release Strap
WARNING!
Do not r ...
Programming The Memory Feature
To create a new memory profile, perform the following:
NOTE: Saving a new memory profile will erase an
existing profile from memory.
1. Turn the ignition ON.
2. Adjust all memory profile settings ...
See also:
Turn signal lever
1 Right turn
2 Left turn
3 Move and hold the lever
partway to signal a lane
change.
The right hand signal will flash
until you release the lever.
4 Move and hold the lever
partway to signal ...
Enhanced Seat Belt Use Reminder System (BeltAlert )
BeltAlert is a feature intended to remind the driver and
front passenger (if equipped with front passenger
BeltAlert ) to fasten their seat belts. The feature is active
whenever the ignition is ...
Theft prevention labels (U.S.A.)
These labels are attached to
the vehicle to reduce vehicle
theft by facilitating the tracing
and recovery of parts from stolen
vehicles. Do not remove
under penalty of law. ...
