Subaru Forester: D (Drive) - Select lever - Automatic transmission - Starting and operating - Subaru Forester Owner's ManualSubaru Forester: D (Drive)

This position is for normal driving.

The transmission automatically shifts into a suitable gear from 1st to 4th according to the vehicle speed and the acceleration you require.

When more acceleration is required in this position, depress the accelerator pedal fully to the floor and hold that position. The transmission will automatically downshift to 3rd, 2nd or 1st gear. When you release the pedal, the transmission will return to the original gear position.

To use the “SPORT” mode, move the lever from this position into the manual gate. To use the manual mode, move the lever from this position into the manual gate then move it toward the “+” and “−” ends.

    N (Neutral)
    This position is for restarting a stalled engine. In this position the wheels and transmission are not locked. In this position, the transmission is neutral; the vehicle will roll freely, eve ...

    While climbing a grade
    When driving up a hill, undesired upshift to 4th gear is prevented from taking place when the accelerator is released. This minimizes the chance of subsequent downshifting to a lower gear when ...

    See also:

    BAS (Brake Assist System)
    Observe the "Important safety notes" section (). BAS operates in emergency braking situations. If you depress the brake pedal quickly, BAS automatically boosts the braking force, thus ...

    To Play a Disc
    To load or play discs, the ignition switch must be in the ACCESSORY (I) or ON (II) position. You operate the disc changer with the same controls used for the radio. To select the disc changer, ...

    Heated Seats
    Uplevel Climate Control System Shown, Base Similar If available, the buttons are near the climate controls. To operate, the ignition must be in ON/RUN. Press or to heat the driver or passenge ...