Suzuki Grand Vitara: Cup Holder and Storage Bin (if equipped) - Other Controls and Equipment - Suzuki Grand Vitara Owner's ManualSuzuki Grand Vitara: Cup Holder and Storage Bin (if equipped)

Cup holders and a storage bin are provided as shown.

To access a bin, push the release button.

To access a bin, push the release button.

To use the console bin, pull the lever up and open the lid.

To use the console bin, pull the lever up and open the lid.

To use the rear cup holders, open the lid.

To use the rear cup holders, open the lid.

or the storage bin to hold cups containing hot liquids or sharp-edged, hard or breakable WARNING: Do not use the cup holder or the storage bin to hold cups containing hot liquids or sharp-edged, hard or breakable objects. Objects in these bins may be thrown about during a sudden stop or impact, and could cause personal injury.

You should hold a bottle with a cap in the bottle holder.
Bottle holder

You should hold a bottle with a cap in the bottle holder.

    Engine Hood
    Engine Hood To open the engine hood: 1) Pull the hood release handle located on the outboard side of the driver’s side of the instrument panel. This will disengage the engine hood lock halfway ...

    Overhead Console Box (if equipped)
    Overhead Console Box (if equipped) To use the overhead console box, push on the front edge (1) and open the lid. To close the lid, push the front edge (1) until it latches. Do not put heavy or ...

    See also:

    Replacing wheels and tires
    When replacing a tire, use the same size, tread design, speed rating and load carrying capacity as originally equipped. (See “Specifications” in the “9. Technical and consumer information ...

    Important safety notes
    WARNING Make sure the tailgate is closed when the engine is running and while driving. Among other dangers, deadly carbon monoxide (CO) gases may enter vehicle interior resulting in unconsci ...

    The Starter Operates Normally
    In this case, the starter motor’s speed sounds normal, or even faster than normal, when you turn the ignition switch to the START (III) position, but the engine does not run. Are you using ...