Nissan Rogue: Checking engine oil level - Engine oil - Maintenance and do-it-yourself - Nissan Rogue Owner's ManualNissan Rogue: Checking engine oil level

1. Park the vehicle on a level surface and apply

1. Park the vehicle on a level surface and apply the parking brake.

2. Run the engine until it reaches operating temperature.

3. Turn off the engine. Wait more than 10 minutes for the oil to drain back into the oil pan. 4. Remove the dipstick and wipe it clean.

Reinsert it all the way.

5. Remove the dipstick again and check the oil level. It should be within the range 1 . If the oil level is below 2 , remove the oil filler cap and pour recommended oil through the opening. Do not overfill 3 .

6. Recheck oil level with the dipstick.

It is normal to add some oil between oil maintenance intervals or during the breakin period, depending on the severity of operating conditions.

Oil level should be checked regularly.

Oil level should be checked regularly.

Operating the engine with an insufficient amount of oil can damage the engine, and such damage is not covered by warranty.

    Changing engine oil and filter
    Change the engine oil and filter according to the maintenance log shown in the NISSAN Service and Maintenance Guide. ...

    See also:

    Disarming the system
    To disarm the system, briefly press the “” button on the transmitter. ...

    Dual view selection
    When the ignition is switched on or the audio unit is turned on after being turned off, single view mode will be the default view. To select dual view, press the dual view hard key on the fascia s ...

    When the System Does Not Seem to Work Properly
    The following messages may be displayed on the DIC: SERVICE PARKING ASSIST: If this message occurs, take the vehicle to your dealer to repair the system. PARK ASSIST OFF: If the URPA system does n ...