Nissan Rogue: Battery saver system - Headlight switch - Headlight and turn signal switch - Instruments and controls - Nissan Rogue Owner's ManualNissan Rogue: Battery saver system

- When the headlight switch is in the position while the ignition switch is in or position while the ignition switch is in position while the ignition switch is in the ON position, the lights will automatically turn off 5 minutes after the ignition switch has been turned to the OFF position.

- When the headlight switch remains in the position or after the lights automatically position after the lights automatically turn off, the lights will turn on when the ignition switch is turned to the ON position.

- When you turn on the headlight

- When you turn on the headlight switch again after the lights automatically turn off, the lights will not turn off automatically. Be sure to turn the light switch to the OFF position when you leave the vehicle for extended periods of time, otherwise the battery will be discharged.

- Never leave the light switch on when the engine is not running for extended periods of time even if the headlights turn off automatically.

    Headlight beam select
    Headlight beam select 1 To select the low beam, put the lever in the neutral position as shown. 2 To select the high beam, push the lever forward while the switch is in the position. Pull it ...

    Headlight aiming control (if so equipped)
    Headlight aiming control (if so equipped) Depending on the number of occupants in the vehicle and the load it is carrying, the headlight axis may be higher than desired. If the vehicle is tra ...

    See also:

    Snow chains
    For safety reasons, Mercedes-Benz recommends that you only use snow chains which have been specially approved for your vehicle by Mercedes-Benz, or are of a corresponding standard of quality. ...

    Dialing from call histories
    1 Select “All calls”, “Missed calls”, “Incoming calls” or “Outgoing calls” using . 2 Select a desired number using  and press the off-hook switch. The following operations c ...

    Hill descent control (green)
    Hill descent control (green) Illuminates when HDC is selected and HDC operating conditions are met. If the lamp flashes, HDC has been selected, but the operating conditions are not being met (e ...