Range Rover Evoque: Seat belt pre-tensioners

The seat belt pre-tensioners activate in conjunction with the SRS to provide additional protection in the event of a severe frontal impact. They automatically reduce any slack in a seat belt to reduce forward movement of a front seat occupant.

will The seat belt pre-tensioners will activate only once and then must be replaced. Failure to replace them will reduce the effectiveness of the SRS in reducing the risk of serious injury or death in the event of an accident.

After any impact, have the seat belts and pre-tensioners checked and, if necessary, replaced by a Land Rover Dealer/Authorised Repairer.

READ NEXT:

 Seat belt safety

Care should be taken to avoid contamination of the webbing with polishes, oils and chemicals, and particularly battery acid. Cleaning may safely be carried out using mild soap and water. The be

 Seat belt checks

Note: If the vehicle is parked on an incline, the seat belt mechanism may lock. This is not a fault and the belt should be gently eased out from the upper anchorage. The seat belts should be inspe

 Seat belt reminder

Seat belt reminder If a front seat belt is not fastened when the vehicle is in motion, a chime will be heard and the seat belt warning lamp will illuminate. Note: Objects on the front passenger

SEE MORE:

 Hill descent control (HDC) controls

Hill descent control (HDC) controls 1. Press to switch HDC on and off. 2. Press to increase the set speed. 3. Press to decrease the set speed. Manual transmission: HDC can be used in 1st, 2nd or reverse gears. Automatic transmission: HDC can be used in D, R and CommandShift 1, 2 or 3. Note

 Inner Back Panel Assembly

Removal NOTES: The inner back panel assembly is manufactured from mild steel. The panel is serviced less its weld studs. The new service panel is not fully spot welded when supplied. It is necessary to remove a section of one rear lamp mounting panel to enable removal and installation of the inn

© 2011-2024 Copyright www.rrevoque.org