Range Rover Evoque: Seat belt checks
Note: If the vehicle is parked on an incline, the seat belt mechanism may lock. This is not a fault and the belt should be gently eased out from the upper anchorage.
The seat belts should be inspected regularly to check for fraying, cuts, wear to the webbing and the condition and security of the mechanism, buckles, adjusters and mounting points.
- With the seat belt fastened, give the webbing near the buckle a quick upward pull. The buckle must remain securely locked.
- With the seat belt unfastened, unreel the seat belt to the limit of its travel. Check that it unreels smoothly with no snatches or snags. Allow the belt to fully retract, again checking for smooth operation.
- Partially unreel the seat belt, then hold the tongue plate and give a quick forward pull.
The mechanism must lock and prevent any further unreeling.
If any of the seat belts fail to meet those criteria, immediately contact you Land Rover Dealer/Authorised Repairer.
READ NEXT:
Seat belt reminder
Seat belt reminder
If a front seat belt is not fastened
when the vehicle is in motion, a
chime will be heard and the seat
belt warning lamp will illuminate.
Note: Objects on the front passenger
Beltminder
A front and rear seat Beltminder system warns
the driver when the seat belt of an occupied
seat is not fastened or is unfastened during a
journey.
Beltminder
A graphic accompanied by a text mes
Child seats
For optimum
safety, children should
travel in the rear of the vehicle at all
times; front passenger seat travel is
not recommended. However, if it is
essential that a child travels in the
fron
SEE MORE:
Airbag system
The components that make up
the
airbag system are sensitive to
electrical or physical interference,
either of which could easily damage
the system and cause inadvertent
operation or a malfunction of the
airbag module.
To prevent malfunction of the airbag system
always consult your Dealer/
Quarter Panel
Removal
NOTES:
Within this procedure there are 2 different options depending on type of
vehicle body and combination of replacement panels.
The quarter panel is manufactured from mild steel.
The rocker panel butt joint in option 2 must be MIG brazed due to the location
of boron reinforcements.
