Volvo XC60: Messages - Parking brake - Your driving environment - Volvo XC60 Owner's ManualVolvo XC60: Messages

Park brake not fully released – A fault is preventing

Park brake not fully released – A fault is preventing the parking brake from being released.

Try to apply the parking brake and release it several times. If the problem persists, contact an authorized Volvo workshop. If you drive off with this error message showing, a warning signal sounds.

Parking brake not applied – A fault is preventing the parking brake from being applied.

Try to apply the parking brake and release it several times. If the problem persists, contact an authorized Volvo workshop. If you drive off with this error message showing, a warning signal sounds.

Parking brake Service required – A fault has occurred. Try to apply and release. Contact a Volvo workshop if the fault remains.

WARNING
If the vehicle must be parked before the fault has been corrected, always put the gear selector in P and turn the wheels so that they point away from the curb if the vehicle is pointing uphill or toward the curb if it is pointing downhill.

    Symbols
    ...

    See also:

    Powered tailgate opening height
    The maximum opening height can be set as required. This is useful in parking areas with low ceiling heights or just for ease of use. 1. Open the tailgate to the position which you want to set as t ...

    Tilt position
    Tilt position, raised at the rear edge 1 Open (raise the rear edge of the front glass section) by pressing the rear edge of the control upward. 2 Close by pulling the rear edge of the control ...

    Seat belt pre-tensioners
    The seat belt pre-tensioners activate in conjunction with the SRS to provide additional protection in the event of a severe frontal impact. They automatically reduce any slack in a seat belt to re ...