Hyundai Tucson: Window defroster switch
Windshield wiper Blade De-icer (If installed)
The windshield wiper blade de-icer is turned on by pushing in the switch. To turn the de-icer off, push the switch a second time. The windshield wiper blade de-icer automatically turns itself off after about 20 minutes.
Rear Window Defroster Switch
The rear window defroster and heated outside rearview mirrors are turned on by pushing in the switch. To turn the defroster off, push the switch a second time. The rear window defroster automatically turns itself off after about 15 minutes. To restart the defroster cycle, push in the switch again after it has turned itself off.
CAUTION: Do not clean the inner side of the rear window glass with an abrasive type of glass cleaner or use a scraper to remove foreign deposits from the inner surface of the glass as this may cause damage to the defroster elements.
NOTE: The engine must be running for the rear window defroster to operate.
Aux outlet (if installed)
You can use an aux outlet to connect an audio device.
NOTE: When using a portable audio device connected to the power outlet, noise may occur during playback. If this happens, use the power source of the portable audio device.
Hazard warning system
The hazard warning system should be used
whenever you find it necessary to stop the car
in a hazardous location. When you must make
such an emergency stop, always pull off the
road as far as ...
Digital clock
There are three control buttons for the digital
clock. Their functions are:
HOUR - Push "H" to advance the hour indicated.
MIN - Push "M" to advance the minute indicated.
...
See also:
Roof Rack System
WARNING
If something is carried on top of the vehicle that is longer or wider than the
roof rack—like paneling, plywood, or a mattress—the wind can catch it while the
vehicle is being driven. ...
Electronic Brake Force Distribution (EBD) system
warning
The brake system warning light also
illuminates if a malfunction occurs in the
EBD system. In that event, it illuminates
together with the ABS warning light.
The EBD system may be malfunctionin ...
Changing the passkey
1 Select “Passkey” using .
2 Select a 4 to 8-digit passkey using
.
Input the number 1 digit at a time.
3 When the entire number to be registered as a passkey has
been input, press again.
I ...
