Subaru Forester: When “CHECK DEVICE” is displayed
This message is displayed under the following conditions.
- When there is a short in the USB bus
- When a non-corresponding device (for
example a USB mouse) is connected
- When a non-corresponding iPod® is
connected
- When a connected iPod® is frozen
- When a transmission malfunction occurs
- When an iPod® confirmation malfunction
occurs
- When a HUB class USB storage
device is connected
Disconnect the USB storage device/iPod®
and check it.
When the following messages are displayed
If one of the following messages is displayed while connecting the USB storage device/iPod®, determine the cause based on the following information. If you cannot clear those messages, please ...When “NO USB” is displayed (type D audio)
This message is displayed under the following conditions. - No USB storage devices/iPod® are connected. - A non-connectable USB storage device/ iPod® is connected. Connect a connectable USB ...See also:
Cleaning the seat belts
Use clean, lukewarm water and soap solution.
Do not clean the seat belts using chemical cleaning agents. Do not dry the
seat belts by warming them above 176 ‡ (80 †) or placing them in ...
Transfer case
This section is only valid for vehicles with 4- wheel drive (4MATIC). Power is
always transmitted to both axles.
Performance tests may only be carried out on a 2-axle dynamometer. The brake
sy ...
Erasing the Car2U Home Automation System buttons
Note: The system allows for three devices to be programmed. If you
need to change or replace any of the three devices after it has been
initially programmed, it will be necessary to erase the curren ...