Honda CR-V: When Can a Larger Child Sit in Front
The National Highway Traffic Safety Administration and Transport Canada recommend that all children aged 12 and under be properly restrained in a back seat.
If the passenger’s front airbag inflates in a moderate to severe frontal collision, the airbag can cause serious injuries to a child who is unrestrained, improperly restrained, sitting too close to the airbag, or out of position.
A side airbag also poses risks. If any part of a larger child’s body is in the path of a deploying side airbag, the child could receive possibly serious injuries.
Of course, children vary widely. And while age may be one indicator of when a child can safely ride in front, there are other important factors you should consider.
Physical Size
Physically, a child must be large enough for the lap/shoulder belt to properly fit. If the seat belt does not fit properly, with or without the child sitting on a booster seat, the child should not sit in front.
Maturity
To safely ride in front, a child must be able to follow the rules, including sitting properly, and wearing the seat belt properly throughout a ride.
If you decide that a child can safely ride up front, be sure to:
Carefully read the owner’s manual, and make sure you understand all seat belt instructions and all safety information.
Move the vehicle seat to the rearmost position.
Have the child sit up straight, back against the seat, and feet on or near the floor.
Check that the child’s seat belt is properly and securely positioned.
Supervise the child. Even a mature child sometimes needs to be reminded to fasten the seat belt or sit properly.
READ NEXT:
Additional Safety Precautions
Do not let a child wear a seat belt
across the neck. This could result
in serious neck injuries during a
crash.
Do not let a child put the shoulder
part of a seat belt behind the back
or un
Carbon Monoxide Hazard
Your vehicle’s exhaust contains
carbon monoxide gas. Carbon
monoxide should not enter the
vehicle in normal driving if you
maintain your vehicle properly and
follow the information on th
Safety Labels
These labels are in the locations
shown. They warn you of potential
hazards that could cause serious
injury or death. Read these labels
carefully.
If a label comes off or becomes hard
to re
SEE MORE:
Alternator and Regulator
Circuit Troubleshooting
1. Make sure the battery connections are good and
the battery is sufficiently charged.
2. Connect a VAT-40 (or equivalent tester), and turn
the selector switch to position 1 (starting).
3. Start the engine. Hold the engine speed at
3,000 rpm with no load until the radiator fan comes
on, then let i
Oil Pan Installation
1. Remove all of the old liquid gasket from the oil pan
mating surfaces, bolts, and bolt holes.
2. Clean and dry the oil pan mating surfaces.
3. Apply liquid gasket, P/N 08717-0004,08718-0001,
08718-0003, or 08718-0009, evenly to the engine
block mating surface of the oil pan and to the inner
thre
