Volvo XC60: Using City Safety
NOTE
The City Safetyâ„¢ function is activated automatically
each time the engine has been
switched off and restarted.
On and Off
In certain situations, it may be desirable to switch City Safetyâ„¢ off, such as when driving in close quarters where leaves, branches, etc.
may obscure the hood and windshield.
When the engine is running, City Safetyâ„¢ can be switched off as follows:
Press My Car in the center console control
panel and go to Settings
Car settings
Driver support systems
City Safety.
Select Off.
If the engine is switched off, City Safetyâ„¢ will reactivate when the engine is restarted.
WARNING
The laser sensor emits light when the ignition
is in mode II or higher, even if City
Safetyâ„¢ has been switched off.
To switch City Safetyâ„¢ on again:
• Follow the same procedure as for switching City Safety™ off but select ON.
Function
Location of the laser sensor in the windshield
City Safetyâ„¢ monitors traffic ahead of you
using a laser sensor mounted in the upper section
of the windshield. If a collision is imminent,
Ci ...
Limitations
The sensor used by City Safetyâ„¢ is designed
to detect cars and other larger motor vehicles
ahead of your vehicle in both daylight and darkness.
However, there are certain limitations and the
...
See also:
Epb warning indicators
If the system detects a fault with the EPB, the
amber brake warning indicator will illuminate
accompanied by a message on the message
centre.
If the system detects a fault while EPB is
operating, ...
ESN/SID Access
With the ignition switch in the ON/RUN or ACC position
and the radio on, press the SETUP button and scroll
using the TUNE/SCROLL control knob until Sirius ID is
selected. Press the TUNE/SCROLL c ...
Check Out Your Vehicle
Before you leave the pavement, be
sure to do all scheduled maintenance
and service, and inspect your vehicle
for any problems. Pay special
attention to the condition of the tires,
and check ...
