Jeep Liberty: To Exit Remote Start Mode Without Driving The Vehicle
Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle.
NOTE: To avoid unintentional shut downs, the system will disable the one-time press of the REMOTE START button for two seconds after receiving a valid Remote Start request.
To Enter Remote Start Mode
Press and release the REMOTE START button
on the RKE transmitter twice within five seconds.
The parking lights will flash and the horn
will chirp twice (if programmed). Then, the
engine will ...
To Exit Remote Start Mode And Drive The Vehicle
Before the end of the 15-minute cycle, press and release
the UNLOCK button on the RKE transmitter to unlock
the doors and disarm the Vehicle Security Alarm (if
equipped). Then, insert the key in ...
See also:
Improving Fuel Economy
The following instructions will help you improve fuel economy.
Avoid excessive idling
If you are to wait for more than a minute while you are parked, stop the engine
and start it again later. When ...
Deactivation
Move the gear selector from R to another position.
There is a slight delay in the PAC system,
which means that the view from behind the
vehicle will remain on the screen for approximately
15 se ...
Full screen view controls
When full screen mode is selected, the seek
controls operate in the same manner as they do
in preview mode.
Display format: Use the relevant soft key to
select the 4:3, 16:9 or Zoom option.
Digit ...
