Mercedes-Benz GLK-Class: Top Tether
WARNING
Always lock the rear seat backrests in their upright position when the rear seats are occupied by passengers. Lock the rear seat backrests in their upright position before installing the Top Tether straps or when the cargo compartment is not in use. Make sure that rear seat backrests are secured properly by pushing and pulling on the seat backrests. If the seat backrest is not locked properly, the seat backrest could fold forward. The child restraint system is no longer supported properly or held in position and can no longer fulfill its function. This could cause serious or even fatal injuries.
Top Tether provides an additional connection between the child restraint system secured with ISOFIX and the rear seat. It helps reduce the risk of injury even further.
The Top Tether anchorages are located on the rear side of the rear seat backrests.
- Move head restraint 2 upwards.
- Install the LATCH-type (ISOFIX) child restraint system with Top Tether. Comply with the manufacturer's installation instructions when doing so.
- Route Top Tether belt 5 under head restraint 1 between the two head restraint bars.
- Route Top Tether belt 5 downward between cargo compartment cover 2 and the rear seat backrest.
- Hook Top Tether hook 4 of Top Tether belt 5 into Top Tether anchorage
3.
Ensure that:- Top Tether hook 4 is hooked into Top Tether anchorage 3 as shown.
- Top Tether belt 5 is not twisted.
- Top Tether belt 5 is routed between the rear seat backrest and cargo compartment cover 2 if cargo compartment cover 2 is installed.
- Top Tether belt 5 is routed between the rear seat backrest and the cargo net if the cargo net is installed.
- Tension Top Tether belt 5. Comply with the manufacturer's installation instructions when doing so.
- Move head restraint 1 back down again slightly if necessary (). Make sure that you do not interfere with the correct routing of Top Tether belt 5.
LATCH-type (ISOFIX) child seat anchors in the rear
WARNING Children that are too large for a child restraint must travel in seats using normal seat belts. Position shoulder belt across the chest and shoulder, not face or neck. In order to a ...See also:
Map split screen
Map split screen
1. TMC (Traffic Message Channel)
information.
2. North is up.
3. Small compass display which always
indicates North.
4. Next direction display.
5. Current vehicle position.
...
Recovering a vehicle that has become stuck
Pull away smoothly, slowly, and in a straight line when pulling
out a vehicle that has become stuck. Excessive tractive power could damage the vehicles.
If the drive wheels have become stuck in ...
Using the Outside Mirror with the Blind Spot Mirror
1. Set the main mirror so that the side of the vehicle can just be seen and the
blind spot mirror has an unobstructed view.
2. When checking for traffic or before changing a lane, look at the main ...