Range Rover Evoque: System difficulties
Use of an incorrect program
will impair
the vehicle's response to the terrain and
can reduce the life of the suspension
and drive systems.
If the system becomes partially inoperable for any reason, it may not be possible to select special programs. A warning will be given when selection of a special program is attempted.
If a participating vehicle system becomes temporarily inoperable, the general program will be automatically selected. Once the system returns to normal operation, the previously active program will be re-activated unless the ignition has been turned off in the mean time.
If the system becomes completely inoperable, all of the special program indicators will be switched off and a relevant message will be displayed in the message centre.
READ NEXT:
Terrain response messages
Messages relating to the Terrain response
system are displayed in the message centre.
See 56, INSTRUMENT PANEL.
Most of the messages that appear will be for
information only and require no driver
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd o
SEE MORE:
Overhead Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. CAUTION: Take extra care not to damage the
edges of the component.
2.
3. NOTE: Do not disassemble further if the
component is removed for access only.
4. CAUTION: Take extra care not to damage the
wiring harnesses.
Transmission Control Module (TCM), Gear Shift Module (GSM)
TRANSMISSION CONTROL MODULE (TCM)
TCM
Neutral 'N' position
Park 'P' position
Position sensor/manual shaft
Electrical connector
The TCM is located on the top of the transmission casing and is connected on
the high speed CAN (controller area network)
bus to send and receive information to and
