Subaru Forester: SRS airbag system monitors - SRS airbag (Supplemental Restraint System airbag) - Seat, seatbelt and SRS airbags - Subaru Forester Owner's ManualSubaru Forester: SRS airbag system monitors

Type A
Type A

Type B
Type B

A diagnostic system continually monitors the readiness of the SRS airbag system (including front seatbelt pretensioners) while the vehicle is being driven. The SRS airbag system warning light “AIRBAG” will show normal system operation by lighting for approximately 6 seconds when the ignition switch is turned to the “ON” position.

The following components are monitored by the indicator:
- Front sub sensor
– Right-hand side
– Left-hand side
- Airbag control module (including impact and rollover sensors)
- Frontal airbag module
– Driver’s side
– Front passenger’s side
- Side airbag sensor
– Center pillar right-hand side
– Center pillar left-hand side
- Side airbag module
– Driver’s side
– Front passenger’s side
- Curtain airbag sensor
– Rear wheel house right-hand side
– Rear wheel house left-hand side
- Curtain airbag module
– Right-hand side
– Left-hand side
- Satellite safing sensor (under the rear center seat)
- Seatbelt pretensioner
– Driver’s side
– Front passenger’s side
- Seatbelt buckle switch (front passenger’s side)
- Front passenger’s seatbelt tension sensor
- Front passenger’s occupant detection system weight sensor
- Front passenger’s occupant detection control module
- Front passenger’s frontal airbag ON and OFF indicator
- All related wiring

If the warning light exhibits any of

If the warning light exhibits any of the following conditions, there may be a malfunction in the seatbelt pretensioners and/or SRS airbag system. Immediately take your vehicle to your nearest SUBARU dealer to have the system checked. Unless checked and properly repaired, the seatbelt pretensioners and/or SRS airbag will not operate properly in the event of a collision, which may increase the risk of injury.

- Flashing or flickering of the warning light
- No illumination of the warning light when the ignition switch is first turned to the “ON” position
- Continuous illumination of the warning light
- Illumination of the warning light while driving

    Example of the type of accident in which the SRS curtain airbag will basically not deploy.
    The SRS curtain airbags are not basically designed to deploy if the vehicle pitches end over end. ...

    SRS airbag system servicing
    - When discarding an airbag module or scrapping the entire vehicle damaged by a collision, consult your SUBARU dealer. - The SRS airbag has no userserviceable parts. Do not use electric ...

    See also:

    Safety Belt Pretensioners
    This vehicle has safety belt pretensioners for front outboard occupants. Although the safety belt pretensioners cannot be seen, they are part of the safety belt assembly. They can help tighten the ...

    Seat heaters
    1 Heats the driver’s seat 2 Heats the front passenger’s seat The indicator light is on while the seat heater is operating. Push the switch once again to turn off the seat heater. ■T ...

    To disengage the service mode
    Turn the ignition switch to the “ON” position, depress and hold the brake pedal, then press and release the “” button on the remote control transmitter three times. The system will p ...