Volvo XC60: Side marker lights
NOTE
Before starting to replace a bulb, see
page 322.
1. Remove the headlight housing from the vehicle (see page 322).
2. Remove the bulb holder by turning it counterclockwise and pulling it out of the headlight housing.
3. Pull out the burned out bulb and install a new one. It can only be inserted in one position.
4. Reinsert the bulb holder into the headlight housing and turn it clockwise.
5. Reinstall the headlight housing.
Turn signals
1. Remove the headlight housing from the vehicle (see page 322). 2. Remove the bulb holder by turning it counterclockwise and pulling it out of the headlight housing. 3. Pull out the holder ...Rear fog light
The rear fog light (located on the driver's side of the vehicle) can be reached from behind the bumper 1. Remove the bulb holder by turning it counterclockwise. 2. Remove the burned out bulb ...See also:
Temperature Gauge
This shows the temperature of the
engine’s coolant. During normal
operation, the reading should be in
the middle of the gauge. In severe
driving conditions, such as very hot
weather or a l ...
Vehicle Cleaning
WARNING: When cleaning the interior
or exterior of the vehicle, NEVER USE flammable solvents such lacquer thinners,
gasoline, benzene or cleaning materials such as bleaches and strong household ...
Front power seat adjustment
Operating tips:
- The seat motor has an auto-reset overload
protection circuit. If the motor stops during
operation, wait for a while, then reactivate
the switch.
- Do not operate the power se ...