Range Rover Evoque: Set or increase cruise speed
When setting the cruise
control to the
speed limit, it is important to remember
that it is possible for the vehicle speed
to increase when travelling downhill.
This may result in the vehicle speed
exceeding the speed limit.
Note: Cruise control can be engaged only at speeds in excess of 30km/h (18mph).
Accelerate until the desired speed is reached, then press control (1). This sets the vehicle speed into the system's memory. Cruise control will now maintain that speed.
The cruise control warning
lamp
will illuminate to confirm cruise
control is operational.
Speed can still be increased using the accelerator pedal. As soon as the accelerator pedal is released, the vehicle speed will return to the set cruising speed.
Note: If the accelerator pedal is pressed for more than 60 seconds, cruise control will be cancelled.
To increase the set cruise speed, press and hold control (1). Release the switch when the desired speed is reached, the new speed will be set and maintained.
The speed can be increased in steps of 2km/h (1mph), by briefly pressing control (1).
Speed can also be increased using the accelerator. When the desired speed is reached press control (1) to set and maintain the new speed.
Note: The set speed can be erased only by switching off the ignition.
READ NEXT:
Decreasing cruise speed
To reduce cruising speed, press and hold
control (4). Release the switch when the
desired speed is reached, the new speed will be
set and maintained.
The set speed can be decreased in steps of
2k
Suspending and resuming cruise control
Suspend cruise control with a single press of
control (3).
To resume cruise control at the previous set
speed, press control (2).
RES (2) should be used only
if the
driver is aware of the set
Automatic switch off
Cruise control will switch off but the set speed
will remain in the memory when:
- The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park
SEE MORE:
Timed climate remote control
The dedicated remote control has a range of
approximately 100m (328ft). Press and hold
the ON button for two seconds.
Note: Avoid touching the antenna when
operating the ON or OFF button.
Timed climate remote control
1. On button.
2. Off button.
3. LED (operation indicator).
4. Antenna.
Electric Booster Heater - Description and Operation
Component Location
COMPONENT LOCATION
Heater assembly
Electric booster heater
Overview
OVERVIEW
Due to the slower warm up times associated with the diesel engine, an
electric booster heater may be fitted to increase
heater performance. The electric booster heater does this by heating the air
