Subaru Forester: Seat heater (if equipped) - Seat, seatbelt and SRS airbags - Subaru Forester Owner's ManualSubaru Forester: Seat heater (if equipped)

- There is a possibility that people

- There is a possibility that people with delicate skin may suffer slight burns even at low temperatures if they use the seat heater for a long period of time. When using the heater, always be sure to warn the persons concerned.

- Do not put anything on the seat which insulates against heat, such as a blanket, cushion, or similar items. This may cause the seat heater to overheat.

NOTE
Use of the seat heater for a long period of time while the engine is not running can cause battery discharge.

1) HI – Rapid heating

1) HI – Rapid heating
2) LO – Normal heating
3) OFF – Off
A) Left-hand side
B) Right-hand side

The seat heater operates when the ignition switch is either in the “Acc” or “ON” position.

To turn on the seat heater, press the “LO” or “HI” position on the switch, as desired, depending on the temperature.

Selecting the “HI” position will cause the seat to heat up quicker.

To turn off the seat heater, lightly press the opposite side of the current position.

The indicator next to the switch illuminates when the seat heater is in operation.

When the vehicle’s interior is warmed enough or before you leave the vehicle, be sure to turn the switch off.

    Active head restraint
    The front seats of your vehicle are equipped with active head restraints. They automatically tilt forward slightly in the event the vehicle is struck from the rear, decreasing the amount of ...

    Rear seats
    Seatbelts provide maximum restraint when the occupant sits well back and upright in the seat. Do not put cushions or any other materials between occupants and seatbacks or seat cushion ...

    See also:

    Publication order forms
    To order the following manuals, you may use either the website or the phone numbers listed below. Visa, Mastercard, American Express, and Discover orders are accepted. If you prefer mailing your ...

    Note for the entry function
    ●Even when the electronic key is within the effective range (detection areas), the system may not operate properly in the following cases. • The electronic key is too close to the window or ...

    Indicator and information symbols
    Fault in the Active Bending Light (ABL) system This symbol will illuminate if the there is a fault in the ABL system. See page 93 for more information about this system. Malfunction ...