Mercedes-Benz GLK-Class: Restarting the tire pressure monitor - Tire pressure monitor (USA only) - Tire pressure - Wheels and tires - Mercedes-Benz GLK-Class Owner's ManualMercedes-Benz GLK-Class: Restarting the tire pressure monitor

WARNING WARNING

It is the driver's responsibility to set the tire pressure to the recommended cold tire pressure. Underinflated tires affect the ability to steer or brake the vehicle. You might lose control over the vehicle.

When you restart the tire pressure monitor, all existing warning messages are deleted and the warning lamps go out. The monitor uses the currently set tire pressures as the reference values for monitoring.

The tire pressure monitor must be restarted when you set the tire pressure to a new value (as a result of changed drive or load characteristics, for example). The tire pressure monitor then monitors the new tire pressure values.

Restart the tire pressure monitor after you have set the tire pressure to the value recommended for the desired driving situation (). Only correct tire pressures on cold tires. Comply with the recommended tire pressures on the Tire and Loading Information placard on the B-pillar on the driver's side. Additional tire pressure values for driving at high speeds or with heavy loads can be found in the tire pressure table on the inside of the fuel filler flap.

  • Make sure that the tire pressure is correct on all four wheels.
  • Make sure that the SmartKey is in position 2 in the ignition lock.
  • Press the button on the steering wheel to or select the Service menu. button on the steering wheel to select the Service menu.
  • Press the button to select Tire Pressure. or Press the button. The multifunction button to select Tire Pressure.
  • Press the display shows the current tire pressure of the individual tires or the Tire button. The multifunction display shows the current tire pressure of the individual tires or the Tire pressures will be displayed after driving a few minutes message.
  • Press the Current Pressures as New Reference Values message appears in the multifunction button. The Use Current Pressures as New Reference Values message appears in the multifunction display.

If you wish to confirm the restart:

  • Press the button.

The Tire Press. Monitor Restarted message appears in the multifunction display. After driving for a few minutes, the system checks whether the current tire pressures are within the specified range. The new tire pressures are then accepted as reference values and monitored.

If you wish to cancel the restart:

X Press the button.

  • The tire pressure values stored at the last restart will continue to be monitored.
    Tire pressure monitor warning messages
    If the tire pressure monitor detects a significant pressure loss on one or more tires, a warning message is shown in the multifunction display. A warning tone also sounds and the tire pressure war ...

    See also:

    Supervisor screen controls
    Supervisor screen controls See 104, TOUCH SCREEN OVERVIEW. 1. Select rear media. 2. Current rear media display. 3. Left screen select. 4. Right screen select. 5. Settings screen. 6. Remote co ...

    Moving to a steep uphill
    Moving to a steep uphill When moving the vehicle up a hill, the distance guide lines and the vehicle width guide lines are shown closer than the actual distance. For example, the display show ...

    Easy Exit Seat — If Equipped
    This feature provides automatic driver seat positioning to enhance driver mobility when entering and exiting the vehicle. To make your selection, press and release the SELECT button until “Onâ ...