Volvo XC60: Reprogramming a Single HomeLink Button - HomeLink® Wireless Control System - Your driving environment - Volvo XC60 Owner's ManualVolvo XC60: Reprogramming a Single HomeLink Button

To program a device to HomeLink using a HomeLink button previously trained, follow these steps:

1. Press and hold the desired HomeLink button.

DO NOT release the button.

2. The indicator light will begin to flash after 20 seconds. Without releasing the Home- Link button, proceed with “Programming” - step 1.

For questions or comments, contact HomeLink at: www.homelink.com or 1–800–355–3515.

This device complies with FCC rules part 15 and Industry Canada (IC) RSS-210. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference that may be received including interference that may cause undesired operation.

NOTE
The transmitter has been tested and complies with FCC and IC rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device.

    Erasing HomeLink Buttons
    To erase programming from the three Home- Link buttons (individual buttons cannot be erased but can be “reprogrammed” as outlined below), follow the step noted: 1. Press and hold the two ou ...

    See also:

    Shortcuts
    Shortcut commands for using the phone can be found in the MY CAR menu system, under Settings Voice settings Voice command list Phone commands and General commands. See page 133 for mor ...

    ON position
    When the switch is in the ON position 1 , the ceiling light will illuminate. ...

    Heated Seats
    Uplevel Climate Control System Shown, Base Similar If available, the buttons are near the climate controls. To operate, the ignition must be in ON/RUN. Press or to heat the driver or passenge ...