Range Rover Evoque: Releasing locking wheel nuts
1. Insert the wheel nut adapter into the
locking wheel nut, ensuring that it is fully
engaged.
2. Locate the wheel brace over the adapter
and unscrew the wheel nut half a turn
counter clockwise.
3. After raising the vehicle on the jack,
remove the locking wheel nut.
Note: After use store the wheel nut adapter
correctly in the tool kit.
READ NEXT:
WARNING - THAT NO PERSON
SHOULD PLACE ANY PORTION OF
THEIR BODY UNDER A VEHICLE THAT
IS SUPPORTED BY A JACK.
Position the jack from the side of the
vehicle, in line with the appropriate
jacking
Do not drive the vehicle if a
tyre is
damaged, excessively worn, or
incorrectly inflated.
Avoid contaminating the tyres with
vehicle fluids as they may cause
damage to the tyre.
Avoid spinnin
SEE MORE:
Special Tool(s)
100-012
Slide Hammer
205-873/1
Remover/Installer, Transfer Case Seal
205-873/2
Protector, Transfer Case Seal
205-873/3
Punch/Screws, Transfer Case Seal
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but
With the headlamps on, AFS will adjust the
beams when cornering to provide improved
illumination in the direction of travel.
When a direction indicator is activated at
speeds up to 40km/h (25mph), an additional
lamp set at 45o in the direction of turn is
illuminated. This broadens the beam of
© 2011-2024 Copyright www.rrevoque.org